Today I made my first analog-cinematography-related equipment - a Braun Nizo S560. I've been into analog photography, mainly large format, for three years now, but I have had no experience with film movies. A long story short, I got this camera for $10, along with a developing tank and reels. As for the related equipment, I'm working on it, there's a lot of second-hand projectors and old film here in Bulgaria.
Anyhow, I digress. Once I put batteries in the camera (both for the film drive and the meter) and flicked the main switch, the camera began shooting and rolling for several seconds, then stopped. When I pressed the trigger below the lens just once, the same thing happened - the camera ran for several seconds and the stopped. Not knowing anything about the various knobs and dials at the moment, I flicked what I later discovered to be the continuous running switch. Upon returning it in its position, I turned the main switch on and the camera began filming, but this time it didn't stop after a period of time. Pressing the trigger did nothing to change that.
As far as I understand, I've done something wrong when adjusting the settings. The camera is now set to some sort of "deafult" Exposure is on automatic, the intervalometer is set to auto, frame rate is 18fps, daylight filter( the sun). Now, every time that I turn on the main switch, the camera begins rolling, and I can't stop it unless I switch it back off. I don't have a super8 cartrige yet, so all tests were done without any film in the cam.
I'll be happy to hear from someone on this, I got very excited about shooting film, as it's been a dream of mine in the past months. I apologize for the bad English, and I hope you could hel me
Nick
